500M带宽，4通道
采样率最高可达2 GS/s
9354AL可达8M存储深度,9354TM可达2M存储深度
Innovative Peak Detect Mode
Fully programmable via GPIB and RS-232-C
Automatic PASS/FAIL testing
Advanced Signal Processing
Internal High Resolution Graphics
Glitch, Pattern, Qualified, Interval, Dropout and Video Triggers
8-bit vertical resolution, 11 with ERES option
DOS Compatible Floppy Disk, PCMCIA potable hard drive and Memory Card options
采集系统
带宽(-3 dB)：DC to 500 MHz
No. of Channels：4 CH
No. of Digitizers：4 CH
最大采样率：2 GS/s
采集存储器：9354AL可达8 M,9354TM可达2M.
灵敏度：2 mV/div to 5 V/div, fully variable.
Scale factors：A wide choice of over 12 probe attenuation factors are selectable.
Offset Range：2.0 - 9.9 mV/div：± 120 mV
10.0 - 199 mV/div：± 1.2 V
0.2 - 5.0 V/div：± 24 V
±20 V across the whole sensitivity range when using the AP 020 FET probe.
DC Accuracy：< or equal to±2% full scale.
垂直分解度：8 bits.
带宽限幅器：30 MHz
输入耦合：AC, DC, GND.
输入阻抗：1 M Ohm//14 pF or 50 Ohms ± 1%.
最大输入：
1 M Ohm：250 V (DC+peak AC < or equal to 10 kHz)
50 Ohms：± 5 V DC (500 mW) or 5 V RMS
时基系统
Timebases：Main and up to 4 Zoom Traces.
Time/Div Range：1 ns/div to 1000 s/div.
Clock Accuracy：< or equal to 10 ppm
Interpolator resolution：10 ps
Roll Mode：Ranges 500 ms to 1,000 s/div.
For > 50k points：10 s to 1,000 s/div.
External Clock：< or equal to 100 MHz on EXT input with ECL, TTL or zero crossing levels up to 500 MHz with option 935XA-CKTRIG.
触发系统
Trigger Modes：Normal, Auto, Single.
Trigger Sources：CH1, CH2, Line, Ext, Ext/10 (9354：CH3, CH4), Slope, Level and Coupling for each can be set independently.
Slope：Positive, Negative.
Coupling：AC, DC, HF, LFREJ, HFREJ.
Pre-trigger recording：0 to 100% of full scale (adjustable in 0.1 div increments).
Post-trigger delay：0 to 10,000 divisions (adjustable in 0.01% increments).
Holdoff by time：10 ns to 20 s.
Holdoff by events：0 to 99,999,999 events.
Trigger Bandwidth：Up to 500 MHz using HF coupling.
Internal Trigger Sensitivity Range：± 5 div.
EXT Trigger Max Input：
1 M Ohm//15 pF：250 V (DC+peak AC < or equal to 10 kHz)
50 Ohms ± 1%：± 5 V DC (500 mW) or 5 V RMS
EXT Trigger Range：±0.5 V (±5 V with Ext/10)
Trigger Timing：Trigger Date and Time are listed in the Memory Status Menu.
- 助您打通产业链！-
